PLASTIC SHEET / TARPAULIN

Material

  • As per UNHCR/UNICEF standard.
  • All our materials are UV-proof, waterproof, rot proof and fire retardant (optional)*
  • Marking and logo customized to your requirements.
  • Designed for long outdoor use in all climates
  • Highly recommended for family shelter protection

 

 Technical specifications
SizeReinforced plastic tarpaulin in 4m x 5m sheet or 4m x 50m roll
MaterialMade of woven high density black polyethylene (HDPE) fibers. warp x weft 12/14 per square inch, laminated on both sides with low density polyethylene (LDPE) coating. With Reinforced rims by heat sealing on all sides (or 2 sides heat sealing and 2 sides double stitching), and nylon ropes in hem, with aluminium eyelets on 4 sides every 100 cm (±5 cm) Centre to Centre.
Weight190 gsm ± 20 g/m²
Tensile strengthMin 600N both directions warp and weft (BS 2576, 50mm grab test or equivalent)
Tear strengthMin 100N both directions (BS 4303 wing tear or equivalent)
UV resistanceMax. 5% loss on mechanical strength after 1500 UV exposure
WeldingOnly 1 welding lengthwise.
EyeletsAluminum reinforcement eyelets or equivalent on 4 sheet sides of single sheets at 100cm (±5 cm) Centre to Centre, providing very strong fixation points

Material

  • As per ICRC/IFRC/MSF/Oxfam standard.
  • All our materials are UV-proof, waterproof, rot proof and fire retardant (optional)*
  • Marking and logo customized to your requirements.
  • Designed for long outdoor use in all climates
  • Highly recommended for family shelter protection

 

                                              Technical specifications
SizeReinforced plastic tarpaulin in 4m x 6m sheet or 4m x 60m roll
MaterialWoven high-density polyethylene (HDPE) black fibers fabric, fabric laminated on both sides with white low density polyethylene (LDPE) coating, reinforced with 6 bands of 75 mm width woven black HDPE fibers fabric and coated with grey LDPE on the outside. Pre-punched 8mm holes on the 2 side bands at 0.1m +/-10% intervals, positioned in the Centre of the bands (only the reinforcement bands are pre-punched, not the tarpaulin itself).
Weight190 ± 20g under ISO 3801 (equivalent to min 170 to 210 gsm max)
Tensile strengthMin 500N, 15-25% elongation in warp and weft in plain sheet under ISO 1421-1
Reinforcement bandsMin 700N as per ISO 1421-1, pulling lengthwise in a pre-punched 8mm hole with a hook of 8 mm wire diameter, at 200mm from the end of the band. UV resistance 80% of original value and not less than 665N.
Tear strengthMin 100N under ISO 1421outside of the Reinforcement Bands.
UV resistanceAfter 1500 hours UV under ASTM G53/94 (UVB 313 nm peak) minimum 80% of original value of the actual product and not less than 475N
WeldingOnly 1 welding lengthwise.